UWE P90, Инструкция по эксплуатации и сборке

Страница: 38 / 77

38
Filter mats in the base housing
1. Unlock the two acrylic locks (6-37/2+3) with the Allen
key.
2. Move the acrylic sheet bed (6-37/1) upward. The
acrylic sheet bed is held in open position by the two gas
springs.
3. Unlock the front apron (6-38/1) with the Allen key (6-
38/2) and move the front apron forward.
4. Pull out the long filter mat (6-39/4) on the bottom of the
controller mounting plate.
5. Pull out the rectangular filter mat (6-23/5) on the air
conditioner.
6. Clamp the new, clean, properly sized filter mats
properly into the grooves of the respective mounting
locations.
7. Move the front apron upward and lock it with the Allen
key.
8. Move the acrylic sheet bed (6-37/1) downward.
9. Lock the two acrylic locks of the acrylic sheet bed (6-
37/2+3) with the Allen key.
Filter mats in the HP modules
All three HP modules are ventilated. There is a ventilation
grate (6-40/2) along each of the long sides through which
the room air is drawn into the HP modules for unit cooling.
Filter mats are located behind the ventilation grates.
1.
As shown to the side, compress the plastic ventilation
grate (6-40/2) on the long sides by pressing at the edges.
2. Remove the ventilation grate.
3. Remove the old filter mat and position the new mat in
the provided mount.
4. Remount the ventilation grate in the HP module.
Replacing the filter glass
The unit must not be used without filter pads! The
uwe logo on the filter pad must be legible from
the bed. Attention when assembling! Unit-specific
configuration of the HP-module filter glass for each module:
5x filter glass, type 322 (coated filter glass)