UWE P90, Инструкция по эксплуатации и сборке

Страница: 28 / 77

28
2. Example: by actuating [STOP] in the program menu P2, the currently elapsed operating hours
are read for the lamps, LP lamps in the bed, High pressure lamps and POWERSPOT in the body
tanner and side tanner.
3. Reading the operating hours: Two values are displayed alternately. The single digit which is
displayed is the ten thousands place; the two digits which are displayed represent the
thousands and hundreds places, respectively.
4. Actuate and hold down [START]. Read the tens and single digit places
5. Simultaneously actuate [START] and [STOP] and hold down for approx. 4 seconds to set the
time counted up to now to zero (25/1) (reset), e.g. after replacing a lamp.
6. If an operating hour counter has reached its limit value, the left decimal point of the 7-
segment display illuminates on the display.
If the unit is disconnected from the power supply within 5 minutes following
completion of the service module, the changed parameters are stored and
activated.
Service menu S1
In service menu S1 you can read:
S1P1: the cooling time of the fan: must not be changed
S1P2: not assigned
S1P3: not assigned
S1P4: limit value of the operating hours for: lamps, LP lamps in the bed, and HP lamps for body
tanner and shoulder tanner module. If the limit value is reached, the
left decimal point on the
display illuminates.
S1P5: limit value of operating hours for: operating hours HP lamp and POWERSPOT shoulder
tanner if the limit value is reached, the left decimal point on the display illuminates.
If the unit is disconnected from the power supply within 5 minutes following
completion of the service module, the changed parameters are stored and
activated.
Service menu S2
In service menu S2 you can read:
S2P1: reading the error memory