UWE P90, Инструкция по эксплуатации и сборке

Страница: 15 / 77

15
4.5 Studio music signal
The music input signal must be a non-amplified signal. If the music input signal is amplified,
it should be reduced with a high-low level adapter.
Adjustment of the sound level can only be conducted in the service menu Pr8 & Pr9.
4.6 Operation using different audio sources
The tanning device can be operated using the following audio sources:
-
External Audio Sources
- Line-In
Connection Line-In. External players as MP3 players, mobile phones (cell phones), iPods, etc.
4.7 Remote control timer operation
The unit is configured for remote timer operation upon delivery from the factory.
Danger to life!
Power down the unit and protect against accidentally being switched back on!
4.8 T-Max Timer (External Timer)
The unit may only be connected by a qualified electrician in accordance with the appropriate
national norm.
Unplug the unit. The T-Max CAT 5 Cable (66/2, 10 meters long) is supplied with every unit. Plug
the plug (66/3) of the T-Max cable into the T-Max adapter (66/4) of the control board. Feed the
cable through the recess (65/1) of the base outside and connect the cables at the T-Max Timer
(66/1). Refer to the connections of the table in picture 66. Information about T-Max operation
can be found within T-Max guide, which is supplied every T-Max Timer.
4.8.1 T-Max Timer (Internal Timer)
T-Max XT Board: Setting address & wiring:
1- Press and hold start & up buttons together until P1 appears
2- Press stop button to enter the P1 address parameter
3- Press the up button to enter the room number
4- Press the stop button until P1 appears
5- To exit hold the up and down buttons together till display goes to zero. Refer to the
connections of the table in picture 67 & 68.