UWE P90, Инструкция по эксплуатации и сборке

Страница: 37 / 77

37
6. Mount the reflector of the POWER SPOT by lightly pressing
against the socket and turning clockwise.
7. Remount the paneling elements.
9.4 Sunlamp
Replacing the LP lamps in the bed
When first used, the lamps may have slight variations in color. This
phenomenon disappears after a short time. The lamps illuminate
darker at the ends. This is a physical phenomenon and not a
defect of the lamp.
1. Unlock the two acrylic locks (6-6/2+3) with the Allen key.
2. Move the acrylic sheet bed (6-6/1) upward. The acrylic sheet
bed is held in open position by the two gas springs.
3. Rotate the defective LP lamp (6-7/4) until the contact pins are
visible in the groove of the base.
4. Pull out the defective LP lamp.
5. Hold the new LP lamp horizontally in such a way that the
contact pins are vertically aligned.
6. While in this position, press the LP lamp into the base. Rotate the
LP lamp 90 degrees so that the notch in the metal ring at the end
of the map is at the top.
7. Move the acrylic sheet bed (6-6/1) downward.
8. Lock the two acrylic locks (6-6/2+3) with the Allen key.
9.5 Filter mats
Replacing the filter mats
The air for unit cooling is guided into the unit at the inlet through
filter mats. There, lint, hair, dust particles, etc. are filtered out. As a
result, the internal unit components, such as lamps, must only be
cleaned at relatively long intervals.
After extended periods of use, these filtered particles plug the filter,
thereby impairing unit cooling. Check the state of the filter mats to
prevent unit overheating. The interval at which this must be
performed is dependent on the operating time and the degree of contamination.
Order the original filter mats only from your specialized dealer or the
unit manufacturer. In any case, check the filters every 200 operating hours.