Uwatec M2, Руководство пользователя

Страница: 56 / 64

56 M2 USER MANUAL
F
NOTE: An apnea dive is stored in the
logbook only when there is at least
one immersion in the session with a
logged depth greater than 0.8m.
As with GAUGE mode, the M2 in APNEA
mode doesn’t carry out any decompression
calculation. You can switch to APNEA
mode only if the computer is completely
desaturated.
The alternate info is shown on the top row
and can be selected by pressing the +/UP
button in the following order:
1. Heart rate.
2. Skin temperature (if SCUBAPRO belt is
used).
3. Temperature.
4. Sequential dive number done in this
APNEA session.
F
NOTE: The ascent/descent speed is
shown as a pop-up when 0.1m/sec is
exceeded in the alternate info field.
The dive depth is shown on the middle row
with dive time shown in minutes and seconds
(after 20 minutes in full minutes only).
On the bottom row, the surface interval
counter counts to 15 minutes. If no
repetitive dive is done, the M2 reverts to
the APNEA mode menu display.
When the SIF is enabled, the no-dive
symbol will be shown at the surface until
this period has elapsed. An audible signal
is given after this.
When the total session depth is enabled
and the limit is reached, the blinking no-
dive symbol is shown and an audible signal
is given.
4.14 SWIM mode
It is sometimes practical to be able to
measure a distance at the surface; for
example, when searching the dive site.
If your M2 has the Surface Exercise mode
enabled, you can count your kick cycles
and measure the distance covered during
the exercise. Naturally, when kick counting
the M2 must be fixed to your ankle.
The M2 can be set to SWIM mode from any
of the surface displays (SCUBA, GAUGE,
APNEA) by a press-and-hold of the +/UP
button.
F
NOTE: The SWIM mode operates
only on the surface. It will switch
automatically to active dive mode
when immersed deeper than 3m/10ft
.