Uwatec M2, Руководство пользователя

Страница: 40 / 64

40 M2 USER MANUAL
4.8.1 Display information
In Dive mode, the display shows you
are in SCUBA mode, it shows the Gas 1
content (21%) and the amount of other
gas mixtures (2G or 3G) if more than one
is enabled. The heart rate symbol will blink
when a HR signal is received. If tank 1 has
been paired with a transmitter, the pressure
is shown after receiving the signal.
Upon immersion, the M2 will automatically
start to monitor the dive regardless of
what state it was in prior to the immersion.
Details on the information displayed can be
found in the following sections.
Dive time: the dive time is displayed in
seconds in APNEA mode and in minutes
in SCUBA and GAUGE modes. If during
the dive you ascend to the surface, the
time spent on the surface will only be
counted to the dive time if you descend
again below 0.8m/3ft within 5 minutes.
This allows for brief periods of orientation.
While on the surface, the time will not
show as progressing but it is running in the
background. As soon as you submerge, the
time will resume, including the time spent
on the surface. If you spend more than 5
minutes at depths shallower than 0.8m/3ft,
the dive will be considered ended, and will
be stored in the logbook. Any subsequent
immersion will cause the dive time to start
again from zero.
Maximum displayed dive time is 999
minutes. For dives longer than that, the
dive time starts again from 0 minutes.
Depth: the depth is given in 10cm resolution
when in metric mode. When the depth is
displayed in feet, the resolution is always
1ft. At a depth shallower than 0.8m/3ft,
the display shows “--.” Maximum operating
depth is 120m/394ft.
No-stop time: is calculated in real time
and updated every 4 seconds. Maximum
displayed no-stop time is 99 minutes.
WARNING:
During all dives, perform a safety stop
between 3 and 5 meters/10 and 15 feet for 3
to 5 minutes, even if no decompression stop
is required.
Temperature: the M2 displays water
temperature during the dive and air
temperature when on the surface.
However, skin temperature influences the
measurement when worn on the wrist.
Decompression information: when the
M2 calculates the need for a mandatory
decompression stop, it shows you how
long and how deep your deepest stop is. It
also gives you the total ascent time. Stops
deeper than 27m/90ft and total ascent times
longer than 99 minutes are shown as “- - “.
4.8.2 Display configuration during
the dive
Throughout the dive, the M2 displays the
most important information with the largest
font on the middle row showing current
depth (left) and elapsed dive time (right). The
no-stop or decompression information is
presented on the bottom row.