Uwatec M2, Руководство пользователя

Страница: 29 / 64

29
English
M2 USER MANUAL
By pressing the SEL button in this display,
the CCR mode, on or off, starts blinking
and can be selected by pressing the +/UP
or -/DOWN buttons. By pressing the SEL
button you will confirm the setting.
4.2.3 Nitrox reset time (“GAS
RESET”)
If you are generally diving with air and want
to return to this setting after the occasional
nitrox dive, you can preset a default time
when your M2 will reset back to air.
By pressing the SEL button the time shown
on the top row starts blinking. The time can
be selected from 1 hour up to 48 hours or
the nitrox reset time can be disabled by
pressing the +/UP or -/DOWN buttons. Gas
reset time is disabled when - - h is shown.
F
NOTE: The nitrox reset disables Gas d
and Gas 2.
4.2.4 Setting the half tank warning
(“HALFTNK”)
By pressing the SEL button the status on/
off starts blinking. You can select the mode
by pressing the +/UP button. By pressing
SEL the pressure value starts blinking and
you may set a value from 50 to 200bar
in 5-bar increments (749..2999psi in 50-
psi increments) by pressing the +/UP or
-/DOWN buttons. By pressing SEL you
confirm the settings.
4.2.5 Setting the tank reserve
(“TANK RESERVE”)
By pressing SEL the pressure value starts
blinking and you may set a value from 20 to
120bar in 5-bar increments (299..1749psi
in 50-psi increments) by pressing the +/UP
or -/DOWN buttons. By pressing SEL you
confirm the settings.
F
NOTE: Reaching the tank reserve
pressure triggers an alarm. In the RBT
calculation the tank reserve pressure
is defining the complete used tank.
The reserve pressure should still be in
the tank when surfacing.
4.2.6 Pairing and mounting of the
high pressure transmitter
(“PAIRING”)
The M2 can receive tank pressure
information from multiple Smart series high-
pressure transmitters. Each transmitter
needs to be mounted on a high-pressure
port of a first stage regulator.
To mount the transmitter, first remove the
high-pressure port plug from the first stage
regulator, then screw the transmitter in
place.
F
NOTE: Use an appropriate wrench to
tighten the transmitter.