BioDoc-It
2
Imaging System
7
81-0358-01 Rev E
Connection for the
main darkroom
power
Connection for
jumper cord to the
transilluminator
Setup Instructions
Components
When unpacking the BioDoc-It
2
Imaging System, the following items will be included:
1. BioDoc-It
2
system with integrated transilluminator
2. Camera and zoom lens
3. Power, jumper and USB cables
4. Ethidium bromide (EtBr) emission filter
5. USB flash drive (8GB minimum)
6. Supporting documentation
7. USB flash drive containing VisionWorks
touch
Software and
8. USB flash drive containing VisionWorks Acquisition and Analysis Software (only for use on an external
computer)
Place the darkroom on a flat surface which can provide adequate support for up to 50 pounds.
WARNING:
Do not attempt to perform any setup procedures while the system is plugged in or powered on
unless otherwise instructed.
CAUTION:
Do not install the system in areas with high moisture, dust or high temperatures. Keep the
equipment away from motors or any other large magnetic equipment. This system is designed for indoor use
only.
Connecting the Power Cables
1. Plug the main power cable into the back of the
darkroom and the other end into a surge-protected
power outlet.
2. Connect the jumper cable from the darkroom to the rear
of the transilluminator.
Installing Emission Filters
To install the 50mm
2
ethidium bromide (EtBr) filter and any other emission filters:
1. Carefully remove the filter from the protective plastic case, holding the filter at the edges to prevent
placing fingerprints on the glass surface.
2. The 2-position filter tray is located at the top of the system, below the camera lens hole. Place the
emission filter in the desired position by inserting the filter through the camera lens hole and into the
desired filter tray position.
Note:
The camera and lens must be removed to access the filter tray.
Additional and replacement emission filters are available through UVP. Refer to the
Replacement
Parts and Accessories
section of this manual for ordering information.
Camera Setup and Installation
The camera and zoom lens are assembled at the UVP factory.
Note:
The zoom lens shipped may appear different than pictured.
1. Remove the cap from the lens.
2. If not already assembled, attach the step-
up ring and diopter to the lens. The step-
up ring and diopter will only fit one way.
3. Using the two brass thumb nuts provided,
secure the camera assembly bracket to
the darkroom bracket located on the top
of the BioDoc-It
2
. Ensure that a light-tight
Step-up ring
Diopter
Camera assembly bracket
