6 Exit the slave configuration procedure by pressing the ON / OFF button. The info's LED will not flash more quickly, thus signaling the exit from the slave configu-
ration mode.
1 Keep pressed the ON / OFF button and wait for the central LED will start to flash rapidly. lhe central signaling LED will flash fast as shown in the picture below,
indicating the configuration state
2 After a few seconds, the remote control will show a sequence of LEDs as shown in the central figure. The LEDs indicate the decoupling mode enabled.
3 Keep pressed the AUTO button to uncouple all the slaves by the system.
PROCEDURE RESET/DECOUPLING OF SLAVE
1 Keep pressed the ON/OFF button and wait for the central LED will start to flash rapidly. The central signaling LED will flash fast as shown in the picture below,
indicating the configuration state
2 After a few seconds, the remote control will show a sequence of LEDs as shown in the central figure. The LEDs indicate the decoupling mode enabled..
3 Keep pressed the SLEEP button to uncouple all the slaves by the system.
PROCEDURE RESET/DECOUPLING OF THE MASTER FROM THE REMOTE CONTROL
13
1
1
2
2
3
3
