7
Figure 3:Package Tester Connections Completed
6.
Turn the fixture upright, and then remove the two transit screws. See Figure 4.
Figure 4: Transit Screws
7.
Connect power supply to the Optima vT’s 24vdc input. See Figure 5.
The systems power supply must be connected to an
earthed (grounded) power supply of 90 - 260V, 50 - 60Hz. Only
personnel trained to avoid the risk of electric shock should remove
the covers on the equipment. The power supply to the equipment
must be switched off and disconnected before removing any covers.
Do not make or break external connectors or connections while the
system is switched on.
8.
Connect the positive pressure to the Optima vT’s air inlet port (optional)
See Figure 5.
9.
Connect serial communication and power cables to the printer (optional).
See Figure 6.
10.
Connect main inlet to power supply unit. See Figure 5.
11.
Turn the Optima vT power On. See Figure 5.
12.
Connect specified air supply, then turn air On to the system. Unit will go
through a boot-up sequence.
