urmet domus Miwi 1032/9, Руководство пользователя

Страница: 70 / 98

DIGITISER REF. 1052/7
PROGRAMMING
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl 70
BUTTONS PROGRAMING
Associated buttons with door phone:
1.
Digitiser connected to the main channel: set number of power
unit, which serve relevant door phone. Dip-switch number 1 is
the least significant bit. If digitiser is connected to the
additional channel skip this step.
2. Press button PROG, call module will generate confirmation
signal, LED comes on.
3. Using dip-switches 1-8 set physical address of door phone
(dip-switch number 1 is the least significant bit). Dip-switch
number 9 specify number of riser (ON-door phone connected
to the second riser).
4. Press button PROG, LED will start blinking.
5. Press relevant button on the panel. Success programming will
be confirm by double signal, LED will stop blinking (shine
continuously). In case of mistake (wrong physical address) will
be generate warning signal, LED will stop blinking. Set correct
physical address and try again.
6. To program next button (door phone connect to the same
power unit), set new physical address, repeat the operation.
To program door phone connect to the other power unit, exit
the programming mode first and start from the beginning,
setting new number of power unit.
7. Press button PROG for 3 seconds to exit.
Dipswitch
settings
Description
Door phone with physical address 6 connect to
the second riser
Door phone with physical address 6 connect to
the first riser
OPERATION INSTRUCTION
CALLING
Press (but not hold) relevant button to make a call. To disconnect
press the same button once again.
CONFIGURATION AND ADJUSTMENT
Desription Settings Function
ADRES
Address
setings.
Address setings.
PR Ą D
ELEKTRO
ZACZEPU
Value of
current.
Current of electrical
lock around 200mA
(work with reverse
electrical lock).
PR Ą D
ELEKTRO
ZACZEPU
Value of
current.
Current of electrical
lock around 300mA.
PR Ą D
ELEKTRO
ZACZEPU
Value of
current.
Current of electrical
lock around 300mA.
PROG Program. Programming button
To change other settings (for example opening time) use call
module with keyboard
Digitiser is pre-adjusted during the manufacturing process.
Potentiometers P1 P2 and P3 allow adjustment of the panel,
however should be perform this step only if it is really necessary.
Function
P1 Adjustment the speaker volume.
P2 Adjustment the locally effect.
P3 Adjustment the sensitivity of the microphone.