urmet domus Miwi 1032/9, Руководство пользователя

Страница: 69 / 98

DIGITISER REF. 1052/7
PROGRAMMING
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl 69
PROGRAMMING
ID SETTING
ID number is important in systems with several entrances. ID must
be unique for each call module (other digitisers and call modules
with keyboard).
Range of digitiser’s ID is 1 – 31. ID number is settings by ADRES
dip-switches.
1.
Use ADRES dip-switches 4-8 to set binary number of ID. Dip-
switch number 4 is the least significant bit. Other dip-switches
(1,2,3 and 9) must be set in OFF position.
2. Press and hold for 3 seconds button PROG, until come on
green LED.
3. If ID number is correct, call module generates confirmation
signal, green LED will be turned off. If ID will be not approved
(for example because of two the same ID number) call module
will generate warning signal, LED will start blinking for 3
seconds.
SETTINGS GROUP OF DIGITISERS
If entrance panel has more than 24 buttons, it is necessary to
create a group of digitisers. One Group consists of max. 4 digitisers
and can managed up to 96 buttons. Group can be supplied by one
power unit ref. 1052/31A or 1052/33. Voice and electrical lock are
condoled by “ZERO” digitiser.
Number of group is set by ADRES dip-switches 4-8, number ID of
digitiser in each group by dip-switches 1-2.
Table with dip-switches setting is on the end of this manual.
Dip-switch
settings
Group
ID
Binary
Description
2 16 Digitiser „zero” for 2
group
2 17 First Digitiser for 2
grup
2 18 Second Digitiser for
2 grup
2 19 Fourth Digitiser for
2 grup
10 145 First Digitiser for
10 grup
10 146 Second Digitiser for
10 grup
Digitiser “zero” can be replaced by call module with keyboard. This
solution allows you to assembly entrance panel with keyboard and
traditional buttons. Voice and electrical lock are served by call
module with keyboard. Call module with keyboard working as
digitiser “zero” must have ID from range 1-31.