urmet domus Miwi 1032/9, Руководство пользователя

Страница: 47 / 98

ERRORS REPORT
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl 47
ERRORS REPORT
Call modules detect and identify lots of errors in MATIBUSse
system. Communication about detected errors will be shown on the
LED display with correct code credited to specific error, based on
this communication we are able to define what kind of error is that.
In the table below we present list of errors code with explanation.
E r 0 1
Short-circuit in riser 1
E r 0 2
Short-circuit in riser 2
E r 0 3
Entering call code too slow
E r 0 4
Logical user code has not been programmed
E r 0 5
Incorrect open code
E r 0 6
Line busy
E r 0 7
Incorrect installer code
E r 0 8
User code without assigned Dallas key
E r 0 9
Incorrect physical code
E r 1 0
Inactivity time too long (in programming
mode)
E r 1 1
Several door phones with the same address
E r 1 2
Dallas key already assigned
E r 1 3
EEPROM full
- - - -
Lack of communication between keyboard
and supplier, for example line D
disconnected
ADJUSTMENT CALL MODULES 1052/13
Call module is pre-adjusted during the manufacturing process.
Potentiometers allow adjustment of the panel, however, should
perform this step only if it is really necessary.
Funkcja
P1 Adjusting the local effect
Adjusting the call module speaker volume
Adjusting the sensitivity of the microphone
Terminals CLS, CLM and CLH allows adjustment the electric lock
current.
Value
Current of electrical lock around
150mA
(work with the reverse
electrical lock)
Current of electrical lock around
300mA
Current of electrical lock around
600mA