CALL MODULES
USER MANUAL
4
FUNCTION OF PS TERMINAL
Call module is equipped with
PS
terminal with connected generator.
Generator parameters can be programmed in programming menu.
It can be used with local ring tones (generator will work, if during
installation between terminals PS and GND there has been speaker
installed).
FUNCTION OF OC1 AND OC2 OUTPUTS
Call module is equipped with two open collector type outputs - OC1
and OC2. Performance of these outputs can be programming in
programming menu.
FUNCTION OF EI1…EI4 INPUTS
Call module is equipped with
EI1…EI4
terminals. Performance of
these inputs can be programming in programming menu.
INDIVIDUAL USER SETTINGS
In BASIC system each user can change his own individual settings,
which are:
•
Change of ring tone,
•
Ring tone volume level adjustment,
•
Opening confirmation in doorphone,
•
Automatic opening after call,
•
Change of individual code,
To enter programming menu:
•
Press
0
button,
•
Press
#
button,
•
Enter individual code,
•
Press
#
button to confirm.
For example: for flat number 1 with individual code 1234 you need
to enter: 0
#
11234
#
After entering correct password the following will appear:
P u 1
Choose function:
1. Ring
tone,
2.
Ring tone volume level,
3.
Opening confirmation in doorphone,
4.
Automatic opening after call,
5.
Change of individual code,
After entering specific function we can:
•
Press
∗
button to exit,
•
Press
#
button to confirm,
•
Enter new value and press
#
button to confirm.
1. RING TONE
P u 1
In this step we can choose 1 of 3 available ring tones.
To save setting press
#
button.
Default setting
0 – global ring tone (step 2.06)
2. RING TONE VOLUME LEVEL
P u 2
In this step we can choose 1 of 4 predefined levels of ring tone
volume.:
1
Volume level - quiet,
4
Volume level – loudest.
To save parameter press
#
button.
Default setting
0 – global settings (step 2.07)
3. DOOR OPEN CONFIRMATION IN DOORPHONE
P u 3
In this step we can choose if we can have confirmation signal in
doorphones after opening the door:
0
Disabled,
1
After entering individual opening code preceded by single
pressing of
#
button or after opening the door with Dallas key,
2
After entering individual opening code preceded by double
pressing of
#
button ,
3
Both 1 and 2 situations.
Default setting
0 – global settings (step 2.02)
4. AUTOMATIC OPENING THE DOOR AFTER CALL
P u 4
In this step we can decide whether we want to automatically open
the door after call or not:
0
Disabled,
1
Enabled.
Default setting
-
0
5. CHANGE OF INDIVIDUAL CODE
P u 5
In this step we can change individual user code. After entering this
step display will fade out:
•
Press
∗
to exit,
•
Enter new password and press
#
button to confirm.
NOTE:
Enter new 4 digit code without flat number prefix.
For example: Prefix for code 12345 is digit 1.
