CALL MODULES
PROGRAMMING
13
4.03
CHANGE / PROGRAMMING OF GENERAL OPENING
CODES
P 4. 0 3
It is possible to program up to 64 general opening codes which can
be assigned to specified call module.
While browsing the codes they are displayed continuously to the
last assigned. Press
#
button to display the next code. If code is not
assigned then „oooo” will be displayed and we can assign it. If there
is no „oooo” on list it mean that all codes has already been
assigned.
After pressing
#
button the first 4-digits general opening code will
be displayed.
After that we can:
•
Browse assigned codes. Press
#
button to confirm,
•
Change selected code by entering new value while it is
displayed. Press and hold
#
button to confirm,
•
Delete selected code by pressing and holding for about 1 sec
∗
button.
Default setting
-
one general code - 6666.
4.04 ADDING DALLAS KEY TO THE USER
The assignment involves assigning a given Dallas key to the
specific user (logical code).
P 4. 0 4
After pressing
#
button the following will appear:
L L L L
Now we can assign call code (logical code) to the Dallas key.
To do it:
•
Enter logical code of the doorphone we want to assign the
given Dallas key. Press
∗
button to exit this option,
•
Press
#
button to confirm. On display should appear four
dashes. If logical code is not programmed certain error
message will be displayed and error signal will be generated
as well. Press
∗
button to exit this option.
- - - -
•
Close Dallas key to the reader within 5 seconds otherwise
Er02 error message will be displayed and error signal will be
generated as well.
•
After successful assignment, double beep will be generated
(confirmation signal). In case of failure Er02 error message will
be displayed and error signal will be generated as well. An
error may occur if given Dallas key has already been assigned
to another code.
4.05
IDENTIFYING / DELETING OF DALLAS KEY (WITH
DALLAS KEY)
In this step we can identify or delete the Dallas key (with Dallas key
use). After entering this step the following will appear:
P 4. 0 5
After pressing
#
button the following will appear:
- - - -
To check to what code the Dallas key is assigned to:
•
Close the Dallas key to the reader,
•
If the Dallas key already exist in the system, then number of
flat will be displayed.
•
Press and hold
∗
button while this number is displaying will
remove this Dallas key from the system. After successful
removal the double beep will be generated and four dashes
will be displayed as well.
•
Press
shortly
∗
button to exit.
4.06 IDENTIFYING / DELETING OF DALLAS KEY (ACCORDING
TO LOGICAL CODE - WITHOUT DALLAS KEY)
In this step we can delete Dallas key from the system (ex: in case of
losing it). After entering this step the following will appear:
P 4. 0 6
After pressing
#
button the following will appear:
L L L L
Now we can delete the Dallas key. To do it:
•
Enter logical code of the doorphone associated with this key.
Press
∗
button to exit option,
•
Press
#
button to confirm. On display should appear serial
number of the key. If to one flat there are assigned more than
one Dallas keys, press shortly
#
button to scroll between
them. After selecting the key press and hold
∗
button to delete
it while its serial number is displayed. In case of entering
unknown logical code on display should appear four dashes.
Press shortly
∗
button to exit option (return to edit mode). After
deleting key the following will appear:
- - - -
•
To delete another Dallas key press
∗
button and enter flat
number again.
