CALL MODULES
PROGRAMMING
12
Press shortly
#
button to leave this parameter unchanged or enter
new value within 0 – 100 range.
The options are:
0
Generator is disabled,
1
Minimal volume,
100
Maximal volume.
Press and hold
#
button to save value.
Default setting
-
0
3.13 ELECTRICAL LOCK – TIME OF WORKING
P 3. 1 3
After pressing
#
button actual value (expressed in seconds) will be
displayed.
Press shortly
#
button to leave this parameter unchanged or enter
new value within 1 – 30 range.
Press and hold
#
button to save value.
Default setting
-
3
3.14 OC1 AND OC2 – TIME OF WORKONG
P 3. 1 4
After pressing
#
button actual value (expressed in seconds) will be
displayed.
Press shortly
#
button to leave this parameter unchanged or enter
new value within 1 – 30 range.
Press and hold
#
button to save value.
Default setting
-
3
4. PASSWORDS, OPENING CODES, CALL CODES,
AND ACCESS CONTROL.
4.01 CHANGE / PROGRAMMING OF LOGICAL CALL CODES
P 4. 0 1
After pressing
#
button the following will appear:
F F F F
FFFF is a physical code (value corresponding with jumper setting in
doorphone within 1-255 range).
We can assign call code (logical code) to every possible jumper
setting in doorphone (physical code).
To do it:
•
Enter physical code of doorphone,
•
Press
#
button to confirm.
If selected physical code didn’t have call code assigned, the
following will appear:
L L L L
If selected physical code has already had assigned call code then
this code would be displayed.
After that we can:
•
Leave current code or enter new one within 1-9999 range,
•
Press and hold
#
button to save.
One logical code can be assigned only to one physical code.
•
If you try to assign existing logical code to another physical
code it will be removed from the old location,
Default settings
- for riser 1 – codes 1 to 100
In case of change of logical code quantity (quantity of
doorphones – if greater than 1.00) – it is required to modify
parameter, and restore logical codes (step 5.06) and individual
opening codes (step 5.07). Logical codes and individual
opening codes will be restored to factory settings (without
relocation) however their quantity will correspond to parameter
value. In analogic way you can also decrease quantity of
codes.
4.02 CHANGE / PROGRAMMING INDIVIDUAL OPENING CODES
P 4. 0 2
After pressing
#
button the following will appear:
L L L L
LLLL
- call code (logical code within 1-9999 range).
In this step we can assign 4-digits individual opening code to the
call code.
To do it:
•
Enter logical call code that we want to assign opening code,
•
Press
#
button to save.
If selected logical code didn’t have assigned any opening code, the
following will appear:
o o o o
If selected logical code has already had assigned opening code
then this code would be displayed.
After that we can:
•
Enter 4-digits opening code or leave the current value,
•
Press and hold
#
button to save or press and hold
∗
button to
cancel it
.
It is possible to assign the same opening code to different call
codes.
Default settings
- Unique codes table.
