Urban Coop Company Round-Top Chicken Coop Walk-In, Руководство по сборке

Страница: 32 / 41

Step 3.5 Egg Box Sub Assembly
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Insert F6 Outer Divider (shorter, no magnets) into
position
Œ
twisting and rotating it into place so as to clear
drip flashing. Secure on front and back edges by driving
Brown T25 screws from F10 into Divider and from B2 into
Divider from within Run. Make sure divider is all the way
down. Repeat for other side.

Insert both F6 Inner Dividers (taller with magnets) into
position

twisting and rotating it into place so as to clear
drip flashing. Make sure divider is all the way down.
Repeat for other side. Make sure edge rails are facing out.
Ž
Insert F9 Upper Feeder Holster Bracket with holes
toward you and tap down until it is several inches below
top edge of F12. Shorter Feeders to front taller feeders to
back.

Trial fit the 4 F3 Feeder Tubes by inserting them gently
into the holster making sure the F6 Bracket is low enough
for them to fully reach ground.

When everything looks good, secure F6 Inner Dividers
on front and back edges by driving Brown T25 screws
from F10 into Divider and from B2 into Divider from within
Run. Then secure F9 Holster using Brown T25 screws.
Note: Straighten up B6 Drip Flashing if needed.
Egg Box Side VieW
(Run Wall Omitted)
x2 x2
F3
Œ Œ
 
Ž
F10
F12
F6 Outer Dividers X2
No Magnets
F6 Inner Divider X2
With Magnets
F9
Lip to
Outside