Urban Coop Company Round-Top Chicken Coop Walk-In, Руководство по сборке

Страница: 15 / 41

Step 1.3 Upper Run Egg Box Side
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Using provided brad nails, attach drip
flashing strip along the top edge of the lower B wall
egg box sub assembly built in previous step,
centering to middle and leaving gaps on ends. See
figure 2.1.A.

Using T-25 brown screws attach upper D1 panel
onto lower back panels assembled in previous step.
Use at least 4 screws, 2 in each section.
Ž
Using T25 brown screws, attach the 4 B1 panels,
sandwiching the B6 flashing, on top of the B2 egg
box door and B3 Mid Strut assembly assemble in
prior steps. Use at least 2 screws per panel.
Beveled upper edges of B1 panels will be slanting
down and out.

Use at least two of the T25 brown screws per
panel to attach the sides of each of the four B1
panels to each other.

Using T25 brown screws attach A3L to the top of
the A2L panel screwing both into A2L and into ends
of B1R.
‘
Make sure back side D1 Upper panel is also
screwd into B1L panel too.
Note: B1 panels will stick up a little beyond tops of
front and back.
B6
Profile
Wood
Brad
Fig
2.1.A
Beveled Edge Slants
Down And Outward
Top Edge Will Stick
Above Ends
Standing Outside Run Looking at Egg Box Wall B
B6 Flashing When Centered
Will Be Short by 1 3/4”
On Each End.
Wire Faces In...