Urban Coop Company Round-Top Chicken Coop Walk-In, Руководство по сборке

Страница: 31 / 41

Step 3.4 Egg Box Sub Assembly
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Install 4X H9 Poultry Nipples into 2X Sections of
F4 Waterer by first seating black rubber grommet into
hole, rotating as required to seat, and then force fitting Red
Nipple into grommet until completely seated.
Note: Observe all instructions and warnings on can of PVC
glue which is packed in end of waterer pipe.

Place the waterer halves in a way that the middles are
near each other, open can of PVC glue and using bottle cap
brush in can smear an even thin coat of glue around inside
surface of larger end of pipe and on outside of surface
of smaller end of pipe . Even thin complete coverage of
glue is required without dry spots. Coat a ~4” section of
ends, about as far as brush will reach in.
Within about 30 seconds of applying glue, insert two halves
of pipe together twisting and rotating hales and at the same
time pushing completely in and lining up Nipples in a row. A
mark is provided to assist you. Glue provided is Regular Set
glue and should give ample working time. Push into ground
if needed to completely join halves. Let dry for 30 minutes
and then rinse out and test. Some water dripping from
Nipples is normal, too much and you should remove nipples
and flush them out as debris may have become lodged in
them.
Ž
Insert F4 Waterer into Coop through F1 Panel With Cutout
and have a helper hold a F5 Water Support Bracket in place
below middle support of F8 Egg Box Floor

aligning the
Waterer to sit against the back side of the B3 strut. Repeat
with other F5 Bracket at position
‘
See Fig
Ž
for detail.
View of Egg Box Wall
(With Waterer Installed in Place)
23 1/2"

‘
Œ
Œ
Screw 2 Brown T25’s From Top
F8 Egg Box Floor
Mid Support
F5 Waterer Support Bracket
F4 Waterer
B3 Strut
Fig
Ž