Urban Coop Company Round-Top Chicken Coop Walk-In, Руководство по сборке

Страница: 21 / 41

Step 1.9 Run Roof Metal
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
The 3X E5 107” long roof panels are predrilled. Lay out outer two panels (holes only in one edge) under the middle upper panel (holes in both edges)
so that you can get holes to substantially line up with ends flush and the double grooves overlapping. Middle panel on top.

Position one of the lower roof panels onto the lower part of the roof using the Eave Magnets to help you hold the panel in place and move it around until it
overhangs ends of the E3 Eaves and E2 Roof Supports by about 1 inch. When you lay over the upper edge of the panel towards the top of the roof the
edge should just overlap and rest on tops of the E2 roof supports. Overhang of the bottom edge of the roof panel beyond the E3 eaves should be about 2
inches.
Ž
Place top roof panel over edge of lower roof panel that is resting on the E2 roof support and align grooves to where they are overlapping and fasten
several of the H10 Neoprene Washer Roof Screws using the H12 Bit Holder with no bit driving screws into E2 Roof support and clamping the lower roof
panel down under the upper panel. See Fig
Ž
. Repeat procedure for other side and then install all of the H10 Neoprene Sscrews tightening them only
enough to compress the washer and not dent the roof metal.
Walls Of Run Built So Far
Are Omitted For Simplicity
Lower E5 107” Galvalume
Roof Panels. Holes Only
In Lower Edges 1 For Each
Side.
1x Upper E5 107” Galvalume
Roof Panel. Holes In
Both Edges
Ends Overhang E3 Eaves
And E2 Supports By ~ 1”
Bottom Edge
Overhangs E3
Eaves By ~ 2 “
Top Edge Rests Just On Edge of E2 Supports
Use roof screws partially
driven to hold roof metal
in place if necessary.
*
Round-Top Walkin Chicken Coop
H10 Screws
Overlap on E2 Supports
H10 Screws
H10 Screws Into E2 Supports
H10 Screws into E2
Roof Metal ~ 2” Overhang Each Side
Fig
Ž
E2
3 Panels 107” Long