Urban Coop Company Round-Top Chicken Coop Walk-In, Руководство по сборке

Страница: 26 / 41

Step 2.4 Roost Bar Detail
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Roost Side View Cutaway
Roost Ramp
Supports
End Roost Bar
Support
3/4 Deep Notch
Œ
Drop in the G8 Mid Roost Bar Support into the G14
Mid Roost Bar Support Brackets tapping into place and drive
1 Brown T25 screw through C4 panel into end of bar and 1 T25
screw through outside G10 Panel into bar end.

Drop in the 4 G4 Roost Bars placing the notches to the
outside facing up. Bars are supported on the ends by the
brackets on the G3 side walls and in the middle by the G8
Support you just installed.
Ž
Drop the 2 G7 Roost Ramp Supports into the notches of the
G4 Roost Bars. Supports sits in notches.

The G6 Roost Ramp Landing rests on the installed block on
the back side of C4 and is held in place by Brown T25 Screws
driven through the C4 Strut into G6 and through the outside G
Roost Wall into the other side of G6. Use provided level if
needed to make level.

The longer G5 Ramp is held in place by provided H23 Silver
5/8” Phillips Screws being screwed through the hinge attached
to G% onto the edge of the G6 landing. Either side is fine.
‘
The shorter G5 Ramps attach on one end to the G7 Roost
Ramp Supports using the H23 Silver 5/8” Phillips Screws and
hinged end of G5 Ramp. Center hinge on G7 up through
centers of bars. Lower edge of G5 Ramp rests on G6 Landing.
’
Attach H8 Eye Bolt & Hook on bottom edge of longer G5
Ramp so that you can hang ramp onto G1 wire roost lower
sidewall, keeping ramp out of way while raking out coop.
C4
G8 Mid Roost Support
G7 Roost Ramp Support
G4 Roost Bars
G6 Roost Ramp Landing
Longer G5 Ramp
Shorter G5 Ramps
Œ

Ž


‘
H8 Eye
Bolt &
Hook
’