UPS Aviation Technologies Apollo SL70R, Руководство по установке

Страница: 15 / 52

Installation Procedures
Apollo SL70R Installation Manual
7
2. I
NSTALLATION
P
ROCEDURES
This section describes the installation of the Apollo SL70R including mounting, wiring,
and connections. A post installation check-out procedure is included in Section 3.
2.1 P
RE
-I
NSTALLATION
I
NFORMATION
Always follow good avionics installation practices per FAA Advisory Circulars AC
43.13-1B, 43.13-2A, or current FAA guidance.
Follow the installation procedure in this section as it is presented for a successful installa-
tion. Read the entire section before beginning the procedure. Perform the post installation
check-out before closing the work area in case problems occur.
2.2 I
NSTALLATION
O
VERVIEW
A successful installation should start with careful planning including determination of
mounting location for the SL70R, antenna location and mounting, connections to an alti-
tude data source, power, cable routing, and other required modifications.
Once the mounting location has been determined, prepare the mounting frame for instal-
lation. It may be easier to complete the wiring harness and attach the connectors to the
mounting frame prior to installing the mounting frame in the aircraft.
2.3 O
THER
R
EQUIRED
M
ATERIALS
In addition to the materials supplied with the SL70R, the following is required.
•
a suitable 2A circuit breaker which the pilot can pull out or disengage must be
used. NOTE: Alternatively, a switch that is within pilot’s reach may be used
in conjunction with a circuit breaker.
•
an altitude data source – either gray code or RS232 (host supplied data)
•
a standard transponder antenna
2.4 S
PECIAL
T
OOLS
R
EQUIRED
Crimp Tool
A crimp tool meeting MIL specification M22520/1-01 and a positioner/locator are re-
quired to ensure consistent, reliable crimp contact connections for the rear 15 pin connec-
tor. These tools are available from:
For pin P/N 245-0027:
ITT Cannon Phone: 714.261.5300
1851 E. Deere Ave. Fax: 714.575.8324
Santa Ana, CA 92705-6500
Insertion tool: ITT part #274-7006-000 (Desc. CIET-20HD)
Regular-duty Crimp tool: ITT part #995-0001-585 (Desc. M22520/1-01)
Regular-duty Locator tool: ITT part #995-0001-244 (Desc. TH25)
Heavy-duty Crimp tool: ITT part #995-0001-584 (Desc. M22520/2-01)
Heavy-duty Locator tool: ITT part #995-0001-604 (Desc. M22520/2-08)