UPS Aviation Technologies Apollo SL70R, Руководство по установке

Страница: 44 / 52

Serial Interface Specification
Apollo SL70R Installation Manual
36
Table 7-14. Ident Table
i Definition ASCII
I Ident Enabled 0x49
- Ident is disabled 0x2d
7.4.2.3 M
ODE
M
ESSAGE
E
XAMPLES
#MD O,-,12006B Standby Mode, Ident inactive, Squawk code is 1200
#MD A,I,235484 Mode A, Ident active, Squawk code is 2354
7.4.3
S
OFTWARE
V
ERSION
The software version message requests the software version be sent. In response the
SL70R will send the configuration message which includes the software versions.
7.4.3.1 I
NTERFACE
S
PECIFICATION
Buffer Length 6 bytes
7.4.3.2 S
OFTWARE
V
ERSION
M
ESSAGE
S
PECIFICATION
Table 7-15. Software Version Message Format
Byte Contents Description
0
‘#’ ASCII ‘#’ (0x23)
1 ‘S’ ASCII ‘S’ (0x53)
2 ‘W’ ASCII ‘W’ (0x57)
3-4 ‘CD’ Checksum = CDH
5 ‘\r’ ASCII carriage return (0x0D)
7.4.4
R
ESET
The reset message will cause the SL70R to reset. It will take approximately 1 second for
the unit to reset after receiving the message.
7.4.4.1 I
NTERFACE
S
PECIFICATION
Buffer Length 6 bytes
7.4.4.2 R
ESET
M
ESSAGE
S
PECIFICATION
Table 7-16. Reset Message Format
Byte Contents Description
0
‘#’ ASCII ‘#’ (0x23)
1 ‘R’ ASCII ‘R’ (0x52)
2 ‘S’ ASCII ‘S’ (0x53)
3-4 ‘C8’ Checksum = C8H
5 ‘\r’ ASCII carriage return (0x0D)
7.4.5
S
ET
O
PERATION
This message sets the SYS_BOOT register in the eeprom and then forces the system to
reset. To exit setup mode, turn unit off, then back on.