22
original remote control) that you
want the MediaRemote with
SimpleCenter to learn.
2.
Press
and
(rewind and fast
forward) at the same timeuntil the
power key blinks twice, then
9 7 5
.
The power key blinks twice.
NOTE:
If the power key displays one long
flash instead, either your batteries
are low, or theMediaRemote with
SimpleCenter has a memory fault.
In either case, the remote will not
learn a new key. See “Additional
Information” on page 28.
3.
Press a device key once (i.e.,
TV,
CBL/SAT,
or
AUDIO
) to assign a
mode for learning, then the key that
will learn the new code. The power
key blinks rapidly, indicating the
remote is ready to learn.
4.
On the original remote, press and
hold the key to be learned. Continue
holding the key on the original
remote until the MediaRemote with
SimpleCenter’s power key blinks
twice.
NOTE:
If the power key displays one long
blink, a learning error has
occurred.Try repeating this step
again until a successful capture
occurs. If the
function is
still not
captured, press and hold
SETUP
to
exit
programming and review the
“Learning Precautions” on the
previous page. If needed, also see
“Troubleshooting” on page 26.
After review, start programming
again at step 1.
5.
Repeat steps 3 through 4 for
another device and/or key or press
OK
to exit programming.
Deleting a Single Learning Key
This process returns the key to its original
programming for the mode you select.
You can also delete learned
programming by teaching a different
function to the key (see “Programming a
Learned Key” on page 21)
2"
Media Remote Rev 1.fm Page 22 Monday, October 3, 2005 4:12 PM
