Unitest Telaris 0100, Инструкция по эксплуатации

Страница: 44 / 108

6.0 Storing Measurement Data
After a successful measurement, it is possible to
save the measurement value by means of „Store”
key (26). Approximately 500 measurement values
can be saved. Proceed as follows:
"
Carry out the measurement.
"
Store measurement result by pressing „Store"
key (26).
"
After successful storing a short signal is audi-
ble and the symbol „M" (16) is displayed. At the
same time the continuous memory address
number briefly appears.
In case of full memory and while pressing key
„Store", the symbol „M" blinks briefly and an
error signal can be heard.
The stored data is maintained even if the in-
strument is switched off or during battery re-
placement.
Double storage of a measurement is impossi-
ble !
Under certain, unintentional circumstances
data may be lost or modified during elec-
tronic saving. CH. BEHA will not be held li-
able for financial and other loss being
caused by data loss, wrong handling or any
other reason.
6.1 Infrared Interface, send Measurement Data
In addition all stored measurement data may be
transferred to the PC (data archive) by means of an
infrared interface. For this purpose, the interface
adapter, available as an optional feature (Cat. No.
1204) as well as the Software „Report-Studio" (Cat.
No. 1204) are required.
The data transfer procedure is easy:
"
Apply the interface adapter to TELARIS 0100
"
Connect adapter cable to PC (COM 2) via 9pole
D-sub plug (RS232).
" Call Software „Report-Studio" (please refer to
user manual „Report-Studio").
" Select menu item „Read data” or select the but-
ton „Read data from measurement instrument”
via mouse click.
"
The message „Send data“ appears.
"
Press key „Send" (27).
Data transfer is carried out. After a few seconds
all stored data is available for further process-
ing in the PC.
For further details, please refer to the user man-
ual „Report-Studio".
44
Storing Measurement Data