Unipulse F160, Руководство по эксплуатации

Страница: 53 / 99

44
6 STANDARD INTERFACES
44
STANDARD INTERFACE
S
Chapter
6
6-1.
External Input/Output (Amphenol Connector)
(Setting Code 60 to 66,70 to 74)
The external input/output signals are selective.
Select necessary signals and set them to each port.
However, in the case of redundant settings to input signals, operation is performed as follows:
- For the timing of edge operation
Functional operation is performed at the edge of any of the input ports assigned with the same
signal.
- For the timing of level operation
The port the largest in number among the input ports assigned with the same signal becomes valid.
■
Connector Pin Assignments
Output assignments
Output allocation
Pin No. Port Setting code Initially-specified signal
1 COM (External power GND)
2
External control output 0 60 01 (SP1)
3 External control output 1 61 02 (SP2)
4
External control output 2 62 03 (SP3)
5 External control output 3 63 04 (Under)
6
External control output 4 64 05 (Go)
7 External control output 5 65 07 (Complete)
8
COM (External power GND)
9 External control output 6 66 11 (Stable)
Set value Signal Set value Signal
00 Near zero 09 Lower limit
01
SP1
10
Upper limit
02 SP2 11 Stable
03
SP3
12
Weight alarm
04 Under 13 Sequence error
05
Go
14
Final error
06 Over 15 In operation (RUN)
07 Complete 16
Clock (in an approximately
one-second cycles)
08 Normally OFF
6
STANDARD INTERFACES