Unipro UniGo One kit 1, Руководство пользователя

Страница: 41 / 56

41
Operating UniGo
R e f e r e n c e
G u i d e
text next to the value will help you identify the
channel.
The bottom line will show the last lap maxi-
mum value for the two channels. This is updat-
ed every time the start/finish line is passed.
RUN MODE 3
The last run mode is used to show only two
data channel values on a kart without gears.
Run mode 3 will show two channel values
and best and max values.
Above the lap time, the lap number and the
recording icon, the best lap time and the best
lap number are shown permanently.
Two big data channel values are shown on the
display. The two channels are configured un-
der ”SET UP SCREENS” on page 30. A small
text next to the value will help you identify the
channel.
The bottom line will show the last lap maxi-
mum value for the two channels. This is updat-
ed every time the start/finish line is passed.
ANALYZE MODE
The analyze menu contains everything
needed to analyze the data directly on UniGo.
Analyzing data will always be faster and better
using a computer though!
The general analyze icon shown above will
bring you to the last analyze screen you were
on. That could be time analysis, min/max or
counters.
It is also possible to jump directly to the ana-
lyze screen you wish from the rolling menu.
SESSION SELECT
UniGo logs data into sessions. Each
session contains all the information about the
race and each time the engine is started, a
new session is made.
List of sessions. Select the one you want.
Use the up ( ) and down ( ) buttons to
move around in the list and press ok button
( ) to either select the session or delete it.
The scrollbar to the right shows where you are
in the total list of files.
The header shows information on the best lap
time, the sessions’ date and time, the track
name and finally the driver’s name.
TIME ANALYSIS
Several screens can be used to analyze
the timing of the race. These screen are listed
in the following section. To change between
the different screens, simply press the
mode
button ( ) until you get to the screen you
want. Different people have different prefer-
ences. Therefore the time analysis screen is
remembered so it will start on the same screen
each time.
OVERVIEW
When starting analyzing a new session, the
overview screen is a good place to start. This
screen will show the three best laps including
the minimum and maximum of three data
channels. It also provides information about
the theoretical best lap time, number of laps
and the average RPM for the whole session
and the starting time and date.