FOODBOX / FOODBOX LONG
Version 3.4 / November 2016
Page 75
After changing the shelf configuration it is important to test the
operational status of the motors. For the purpose enter Opera-
tor’s menu and select menu item SNACK/MOTOR TEST (input
cell number) – see section MAiNTENANCE MODE.
Fig.41 - Shelf with double width cells
ATTENTION! This test assumes the dispensing of product from the tested cell
into the dispenser tray. If this would not happen following a complete turn of the
motor, the spiral will be rotated completely and the test will end with “FAILURE”
notice.
4.6.2.2 Alteration of shelf configuration to convert single space cells into l
½ width cells
Figure 42 shows the overall view of the shelf with 1½ space cells for selling medium width products.
• Remove two spacers (see fig 38 position 1);
• Disconnect and remove two motors with spirals (see fig 38,
position 2) – see section 4.6.2.1;
• Reset two spacers and two motors with spirals (see fig 38
position 3,4) one step in the installation spot on the shelves.
Fig.42 - Shelf with 1½ width cells
4.6.2.3 Additional accessories
132 mm
93 mm
When selling wide dimensional products, it is recommended to
use higher vertical spacers (see fig 43).
Fig.43 - Spacers