FOODBOX / FOODBOX LONG
Version 3.4 / November 2016
Page 32
As per the structural design of the Machine it is possible to fix the Machine to the wall (relevant set of
fixings is included in the base package).
The manufacturer recommends, if possible, to use this set of fiasteners.
The fitting of the Machine to the wall can be the only fitting or can act as the supplementary fitting, which
can help avoid tipping over of the Machine in case of attempts of vandalism.
Fixing the Machine to the wall:
1.
Remove the transportation pegs (see figure 22) and self-tapping screws from the dispensing tray;
2.
Screw on the pegs with four screws (see figure
23);
3. Displace the Machine to the wall;
4.
Mark the holes for fixing the Machine;
5. Pull away the Machine from the wall and drill dead holes for
installing the plugs;
6. install the plugs and again move the Machine to the wall
so that the holes in the wall would coincide with the holes in
the pegs, then fix the Machine using self-tapping screws (see
figure 24).
Fig.22 -
Supports for fixation to the wall
Fig.24 - installation of supports on the given wall of the Machine
1 - Self-tapping screws
2 - Plug
Fig.23 - Fixing the Machine to the wall
ATTENTION! In case if you fix the Machine to the floor and the wall, it is necessary to
first fix the Machine to the wall and only then fit it to the floor!
