UTL8200 User Manua
12
3.1 Power on and Run
The correct power-on and self-inspection processes of the electronic load are as follows:
1. To power the electronic load on, please connect the power cable correctly, and press
the power button on the front panel. The electronic load screen will display the
progress bar of current power-on and self-inspection.
2. After initialization, the measuring status will be displayed on the screen. If the start-up
mode has been set, the instrument will enter the preset measurement mode directly.
The completion of correct power-on and self-check indicates that the load meets the
factory standards, so users can use it normally.
Warning:
Please make sure that the power supply voltage is consistent with the
supply voltage before turning on the power, otherwise the instrument will be burnt out.
Please be sure to connect the main power plug to a power socket with ground protection.
Do not use a wiring board without ground protection.
3.2 Measurement Interface
3.2.1 Introduction of Screen Display
After entering the test mode, the LCD screen will be divided into several areas to display
different information. Take the UTL8212 dual-channel CC mode display interface as an
example, as shown in Figure 3-2-1.
Figure 3-2-1 CC Mode Display Interface (UTL8212)
