Ultrak CCU-100HD, Руководство пользователя

Страница: 21 / 154

1-5
When a video alarm occurs, the CCU starts the MultiCall assigned to the video
alarm type. The default MultiCall for all video alarm types is 000. Refer to
Section 4 of this manual for programming the MultiCall for each alarm type.
The CCU also sends a message to the JPD-100 Joystick Controller indicating a
video alarm and the channel involved. The oldest video alarm is displayed on
the JPD-100 LCD display. Video alarms are acknowledged by an operator at the
JPD-100 Joystick Controller. Refer to the JPD-100 Controller User’s Manual for
acknowledging alarms.
The CCU sends all pan, tilt, and camera lens commands including PreShot and
VectorScan commands to the HD switcher. The HD switcher has eight control
output ports for pan and tilt cameras. The HD switcher converts the control data
to the protocol (Diamond, Maxpro, Pelco, etc.) selected in the switcher. Refer to
the HD switcher user’s manual for setup of the HD switcher.
•
Host Computer Input
The CCU has an RS-232 input (COM1) for a host computer. The host computer
can send data packets to the CCU to switch a camera to a monitor, send a
SmartScan to a PreShot, start a VectorScan stored in a SmartScan, activate an
alarm, reset an alarm, or run a MultiCall.
1.3 SPECIFICATIONS
ELECTRICAL
Power Requirements: Selectable
110-120V, 50/60 Hz, 0.13 Amps
220-240V, 50/60 Hz, 0.06 Amps
Fuse: Rear Panel, 5 x 20mm fuse holder
120V - 1/4 Amp
220V - 1/8 Amp