1. Remove crumb trays and/or
shelves from both ends.
DIRECTIONS FOR DISASSEMBLY
2. Push the spring-loaded
coupling in to disengage the
pin in the shaft. Rotate the
shaft so the pin will not go
back in the coupling slots.
4. Finish removing the conveyor
assembly from the right end
of the oven.
3. Lift up the left end of the
conveyor frame so the crumb
tray supports (UM1850 only)
clear the tunnel opening.
Push the conveyor frame
through the opening.
5. Upper fi nger assembly can
be removed complete or
the small handle (left) can
be used to slide nozzle and
columnating plate out before
removing the main body.
7. The lower fi nger assembly can
be removed complete or the
nozzle can be slid off to reveal
the recessed columnating
plate.
6. Upper nozzle (with slot) and
columnating plates (with tab).
Extruded holes all point in the
same direction (down toward
the conveyor).
8. The columnating plate also
has a slot that must align with
a tab on the fi nger to ensure
proper orientation. Extruded
holes point up toward the
bottom of the conveyor.
9. The oven body is now ready to
be wiped clean. Reassemble
the fi nger and conveyor parts
in the reverse order after
cleaning.
