Ultimate Jets
- Phoenix Mk2 assembly manual - Revision 2 - 08/11/2013
Rudder servos :
Proceed as for the stabilizer servo :
Adjust the pocket to the servo size
using a carbide rotating file.
Fasten the servo in the servo cover
(you can also glue it with silicon glue
for improved safety).
Place the servo cover on the boom.
Drill four 1 mm holes through the
covers into the booms.
Cut a slot in the control surface for the
fiber control horn.
Glue the control horn with Hysol
E20HP.
Connect two 2 mm link with a M2
threaded rod.
Fasten the servo cover with the 4
countersink sheet metal screws.
Connect the servo to the control horn.
Apply thread lock.
Make a 20 mm hole in the boom in front
of the hole of the wing root for the servo
harness.
Drill this hole on both sides of each
boom.
Solder the rudder electric harness.
Make a 5 mm hole in the boom in front of the stabilizer root to pass the harness.
Don’t make the hole too big so that the plug can’t fall in the boom.
Solder the elevator harness.
