UGO BASILE 37370, Инструкция по эксплуатации

Страница: 20 / 44

Page 13
37370 Instruction Manual (Rev. 0)

experiment number (see 5.6.2)

animal gender (see 5.6.3)
From the main menu, depress the
F2
(
FNC
) key, followed by the
F1
(
OUT
) key. Depress
again the key
F2
(
FTR
); the display shows the first setting, the sequence number.
All the available selections for each additional information are displayed in a loop. Scan
them by the
F1
(
UP
) or
F2
(
DWN
) keys, select the suitable one and confirm the selection
by depressing the
F4
(
OK
) key, or avoid one or more features by depressing the
F3
(
NUL
) key.
The selected features will be maintained even if the instrument is turned off.
To erase one or more features previously set, simply enter this software level, highlight
the concerned feature and depress the
F3
(
NUL
) key.
After entering the last feature (M or F), the software goes automatically back to the main
menu.
5.6.1 Sequence Number
The first additional information to be de-
fined is the sequence number. This section
is highlighted as soon as the
F2
(
FTR
) key
is depressed.
Use the
F1
(
UP
) or
F2
(
DWN
) key to set
the desired sequence number from 01 to
99 and confirm it by depressing the
F4
(
OK
) key.
The sequence number will automatically increase by one figure at any subsequent
measurement. It trips once a datum has been acquired and recorded, indicating the fresh
sequence number ready for the next measurement.
If a sequence number is not necessary, depress the
F3
(
NUL
) key.
IMPORTANT:
When a fresh experimental session is begun, the sequence number can be
carried on from the number reached at the end of the previous trial or a new
number can be entered, following the instructions outlined above, for exam-
ple starting from 01.