22
Menu 04: Module Type Select
Your reports can reflect the module used for your inspection. You can choose:
SCM
(Scanning Module),
STM
(
Stethoscope
Module
),
UWC
(
The Parabolic Dish
)
CFM
(
Close Focus Module
),
LRM
(
Long Range Module
) or
OTH
(
Other
).
To select a
Module Type
:
1.
Follow the steps to Enter the
Setup Mode
as described earlier.
2.
Spin to Menu 12:
Module Type Select
3.
Click to Enter
4.
Spin to select a
Module
5.
Click to set
6.
Press the
Yellow ENTER button
to exit.
Menu05: Instrument Setup
There are two choices for Instrument Setup: Manual and Auto.
Menu 06: Alarm Enable/Disable
To Enable or Disable the
Alarm
,
1.
Follow the steps to Enter the
Setup Mode
as described earlier.
2.
Spin to
Menu 05, Alarm Enable
3.
Click the
Sensitivity Control Dial
to enter
4.
Spin to select
Enable
or
Disable
5.
Click to set
The
Alarm dB
level can be set when
Enable
is selected and the instrument is in the
Operation Mode
. To do so,
1.
Click down to bottom of the meter until
PRESS ENTER FOR
:… is blinking
2.
Spin to
Alarm Enable
3.
Click to
Enter
4.
Spin to the desired
dB Alarm
level
6.
Click the
Yellow ENTER button
to exit
Menu 07: Set Record Time
The recording time can be preset using this feature. The selections are: Manual (hold the sensitivity dial in for as long as you wish to
record while recording) 5, 10,15,20,25, 30 seconds. To Select a recording time:
1.
Follow the steps to Enter the
Setup Mode
as described earlier.
2.
Spin to
Menu 07, Set Record Time
3.
Click the
Sensitivity Control Dial
to enter
4.
Spin to select manual or desired record time
5.
Click to set
Menu 08 Record WAV on Alarm
When an alarm level is exceeded during an inspection, the instrument will launch into the alarm mode and will use the preset record
time modes as described above in Menu 07 Set Record Time.
1.
Follow the steps in Enter the
Setup Mode
as described earlier
2.
Spin to
Menu 08
,
Record WAV on Alarm
3.
Click the Sensitivity Control Dial to enter
4.
Spin to select YES or NO
Menu
12
Select
Module Type Select
Press ENTER to Exit
Module Type Select
Module = (STM)
60 dB
40 kHz
S=69
RT
Press ENTER
for Alarm
Set Alarm Value
Current Alarm Value
( 120 dB )
Press ENTER
for Setup Menu
