UDEVAC-500
36
31
610.592A
Rev.
1
"Fire mode"
to configure the parameters of the actions and events that the control
equipment must take in the event of an evacuation or alert message being activated.
"Alarm mode config"
Selecting this button will open the window (Down
indicated) where we can configure:
In this window we can select "
All zone
", "
Specify
zone
" and "
Neighboring mode
".
If we select "
All zone
" it means that once the fire alarm is activated through the "
Trigger Inputs
"
contact inputs of the control or expansion equipment, all the loudspeaker zones will be activated
and the evacuation message will be heard in them.
In this operating mode we can also configure the
playback mode in window
"All repeat"
the message is repeated until a reset is
done.
"One repeat"
the message is played only once.
"Host contact config"
In this window we can select the device (Host 01 Main device, Host 02 Expansion device, Host 03
Expansion unit, etc.) in order to configure the alarm activation inputs of each of the units.
In this window we can select the evacuation message or the alert message to be used as an emergency
message in case of fire.
In this window we can select the input contact that will activate the message selected in "6" and of the
equipment selected in "5".
This window is used to select the speaker zones where the message selected in "6" will be activated and
the equipment selected in "5", this window will only be active if in "Alarm mode config" in window "1" we
have selected the specific zones option "Specify zone".
this is the time in seconds of delay in the activation of
the alarm and the output of the voice message from
Evacuation in all speaker zones of the system (control
equipment and expansions).
1
2
3
5
6
4
1
2
3
4
5
6
7
7
