36
9
610.592A
Rev.
1
UDEVAC-500
6. LAN input for Configuration Software.
It is used to connect with the SF-500 configuration software, for programming and manual adjustment and
control operations.
Note:
1) Default IP address: 192.168.1.168, communication port number: 16888
2) To restore the default IP address, activate and deactivate DIP switch number 6 on the rear panel of
the control unit once.
3) If you want to change the ip address, please enable DIP switch number 5 to enable DHCP function.
Make sure the DHCP function is enabled.
4) The SF-500 software will help you to configure the SLA-500M evacuation equipment. All
communication cables must comply with TIE/EIA-568B standards, including connections to the SLA-
500S expansion modules and the PZ-500 and PZ-500F paging microphones.
7. Input for SLA-500 S expansion modules and PZ-500 and PZ-500F paging microphones.
Use a pin-to-pin CAT6 UTP cable (TIE / EIA-568B standard) to interconnect all the devices that make up the
UDEVAC-500 system, the maximum communication distance is up to 600 meters. Loop or star connection of
all connected equipment is possible, the SF-500 software will automatically detect the connection mode of the
system.
8. SD memory card for emergency messages.
System emergency messages are stored on the SD memory card, evacuation and alert messages are
monitored in real time, maximum capacity of 32 GB SD memory card. SD memory card supports a maximum
of 255 messages. Never handle this card with the equipment turned on. Do not delete or manipulate the files if
you are not sure, make a backup copy of the original files before making any changes, otherwise the
equipment may stop working and will not come under warranty.
VERY IMPORTANT THE AUDIO FILES
MUST BE IN "WAV" FORMAT.
In the root directory of the SD card there are 3 folders:
- BGM folder for music.
- EVAC folder:
"alert_message"
where the alert message is. To
change the alert message we must replace the
audio file by putting the new file (WAV) with the
same name as the one originally in the folder.
“evac_message"
where the evacuation
message is stored To change the evacuation
message we must replace the audio file by putting
the new file (WAV) with the same name as the one
originally in the folder.
"log"
where the event log is stored.
where the equipment configuration is stored. VERY
IMPORTANT DO NOT HANDLE THIS FOLDER.
"parameter_disable_del"
where the equipment configuration is stored.
VERY IMPORTANT DO NOT
HANDLE THIS FOLDER.
- PROMPT folder:
within this folder are the "Ding Dong" warning tones that are emitted at the beginning and at
the end of voice messages, the warning tones can be modified according to customer requirements and be
replaced by others (Format WAV) these tones are for all notification desks, these warning tones are not
supervised in real time, they are only supervised once when the equipment is turned on, so if there are no
warning tones or the file has been lost, do not will be warned as a failure.
