UBI EasyCoder 601 XP – Service Manual Ed. 1
80
Chapter 11 Paper Cutter
• Tilt the cutter unit upwards until it locks into place. If the cutter
does not lock properly, the hinges of the cutter unit may need to
be adjusted using a #T10 Torx screwdriver.
• Put back the power cord and switch on power. The cutter will
perform an idle cycle in order to occupy its home position.
• Turn off the power. Tilt down the cutter and thread the paper
through the cutter unit between the guide plates (see illustration
above). Then tilt up the cutter again and lock it in closed position.
Check that the printhead is lowered and turn on the power. Now
the printer is ready for operation.
The spring that presses the anvil blade against the rotating shear
may eventually get slack, especially if the anvil blade is forced open,
e.g. during cleaning. A slack spring must be replaced as follows:
• Remove the right-hand gable of the cutter (two #T20 Torx
screws).
• Remove the right-hand gable of the cutter mechanism (two
#T20 Torx three Posidrive screws).
• Replace the spring and assemble in reverse order, making sure
to put back all the washers.
11.4 Installation,
cont'd.
Hinge
Guide Plates
(insert paper between the plates)
Hinge
11.5 Spring
Replacement
