UBCO 2X2, Руководство пользователя

Страница: 23 / 29

42 43
Warning Light
The warning light will signal that there is a problem by flashing a series of codes. Stop the bike, hold it
stationary and follow the solution indicated by the flash code. If flashing does not stop, or the code is not
listed, discontinue riding and contact your service provider.
PROBLEM FLASH CODE SOLUTION
Motor Hot _ . . . . . _ . Long, 5 short, long, short Slow bike or rest.
Motor Overheat Shutdown _ . _ . . Long, short, long, 2 short
Turn bike off. Wait 10 minutes for motor to cool
down. Clean mud off motor.
Controller Hot _ . . . . . _ . . Long, 5 short, long, 2 short Slow bike or rest. Clean mud from front of bike.
Controller Overheat Shutdown _ _ . . . . 2 long, 4 short
Turn off bike and rest 10 minutes. Clean front
panel behind front wheel.
Low Voltage
_ _ . . . . . . .
2 long, 6 short Check battery plug. Charge battery.
Motor Sensor Fault _ _ . . . . . 2 long, 5 short
Check motor plug is clean and connected.
Check motor cable for damage.
Power Surge Protection _ . _ . Long, short, long, short Turn key off, then on.
Throttle Communication Fault _ . _ . . . Long, short, long, 3 short Contact your service provider.
3 Front Left
Accessory Lugs
3 Front Carrier
Accessory Lugs
5 Rear Left
Accessory Lugs
Loading up your bike
The 2×2 is unique in featuring 16 accessory lugs
on the frame, plus three on the front carrier,
for attaching tie downs, mounts and other
accessories. This will allow you to adapt the
bike to suit your needs. These lugs have been
positioned strategically on the frame to provide
maximum flexibility.
Do not load the front carrier over 20kg.
The accessory lugs use standard M8 bolts. They
contain a cavity to house an M8 nut, preventing it
from spinning as the bolt is tightened or loosened.
Check your tyre pressure aligns with the load
guidelines on page 31.
To ensure a safe ride, always load up
your 2×2 properly.
Do not allow the load to impede the
bike's moving parts or steering.
See Loading Limits in Section 01: Safety.