UAZ UAZ-220695, Руководство по эксплуатации

Страница: 34 / 90

34
Do not stand on knees on a seat equipped with heating elements, and do not load individual points of the seat surface
in any other way so as not to damage its heating elements.
Do not place objects with irregular weight on the seats or stick sharp objects (needles, nails, etc.) into the seats.
Do not use seat heating if the seats are not occupied by passengers, or there are objects attached to them, e.g., a
special child seat, a bag, etc. This may cause malfunction of the heating elements of the seat heating system. It is
recommended to turn on the switches for seat heating only after starting the engine. This will significantly save battery
capacity.
In the event of a voltage drop in the vehicle’s electrical system, the seat heating i
s automatically switched off in order
to provide enough electricity to control the engine.
If you or a passenger suffer from a reduced sensation of pain or temperature, for example, due to the use of any
medication, paralysis or chronic disease, we recommend that you do not use heating. This can cause burns on the back,
buttocks and legs. If you still want to use seat heating, we recommend turning on the seat heating for a short time.
Do not allow the use of additional pillows between the seat and the passenger or driver.
Foreign objects under the driver’s seat and in the area of his feet is unacceptable.
Do not keep your hands under the seat or near moving parts, to avoid pinching and injuring your hands or fingers.
When cleaning the seats, do not use organic substances (paint thinners, petrol, alcohol, gasoline, etc.). They may
damage the heater and the seat surface.
Adjustment of the reclined front seat backrest is performed by turning knob 2 (Fig. 3.7).
Adjustment of driver's seats in longitudinal direction is performed with lever 3: Push the lever, located on the outside
near the backrest tilt mechanism, all the way down, slide the seats to the required position. After adjustment release the
lever, and make sure that the seat is securely fixed by moving it back and forth.
Removal of the front seat:
- Unscrew the wing nut 1 (Fig. 3.7) and tilt the seat forward;
- raise the studs located on the seat from the bushings 4 located on the wheel cover. Remove the seat.
To install the seat, insert the studs in the bushings, tilt the seat back and tighten the wing-nut 1.
Fig.3.7 Front seat:
1 - wing nut; 2 - seat back tilt adjustment knob (kiper); 3 - seat longitudinal movement locking lever (driver's seat); 4 - bushings
Seat belts
REMEMBER! Seat belts are an effective means of protecting the driver and passengers of a vehicle from the
serious consequences of road accidents. The wearing of seat belts is mandatory!
Seat belts are designed for individual use by drivers and adult passengers with a height of at least 144 cm and a
weight no less than 36 kg.
The vehicle seats are equipped with seat belts. The front belts of driver's and right front passenger's seat are of
diagonal type with retractor (Fig. 3.8).
In the cabin of UAZ-220695, UAZ-220695-04, UAZ-396295, UAZ-374195-05 the belts of the seats located in the
direction of movement of the vehicle are of diagonal type with a retractor device, and the belts of the seats located against
the direction of the movement of the vehicle are of lap type with a retractor device (Fig. 3.9.).
In the cabin of UAZ-390995, UAZ-390995-04, UAZ-390945 the belts of seats located in vehicle driving direction
are of diagonal and lap type with a retractor device, and the seats located against the driving direction (UAZ-390995- 04)
are of lap type with a retractor device (Fig. 3.10, 3.11).
To fasten the belt, take the belt locking tab 1 and, without twisting the straps, insert it into the lock 2 until it clicks. To
unfasten the belt, press button 3.
Keep the straps and belt buckles clean. If contaminated, clean with alkaline-free mild soapy solution.
Protect the straps from friction against sharp edges.
It is recommended to protect from direct sunlight.