UAZ UAZ-220695, Руководство по эксплуатации

Страница: 53 / 90

53
Fig. 9.11 Clutch release cylinder:
1 - connection pipe; 2 - piston spring; 3 - cylinder housing; 4 - piston; 5 - sealing collar; 6 - protective cap; 7 - lock ring; 8 - piston rod;
9 - blow-off valve; 10 - cap
Please note! The length of push rod 8 is 112 mm. Do not adjust the length of the push rod during operation.
Fig. 9.12 Clutch release master cylinder drive:
а
- fluid level;
1 - tank; 2 - main cylinder; 3, 4 - pipes; 5 - pedal; 6 - push rod
Gearbox and transfer case
If you find a leak, find the cause and replace defective parts (gaskets, collars), on the threads of through bolts and the
planes of the connector apply car sealant-gasket. Checking the oil level and its replacement in the gearbox and transfer
case must be done simultaneously. The level shall be at the bottom edge of the filling opening (Figs. 9.13, 9.14).
During vehicle operation, the lubricant level in the gearbox can be lowered down to 8 mm relative to the lower edge
of the inspection hole and at the same time it can be raised in the transfer case. It is not necessary to level out the
lubrication levels.
Fig. 9.13 Gearbox plugs:
1 - filler plug; 2 - drain plug Fig. 9.14 Transfer case plugs:
1 - the filler plug; 2 - the drain plug
Driveline
The splined joint is lubricated through the grease nipple 1 (Fig. 9.15), screwed into the spline yoke and the needle
bearings are lubricated through the lubricating nipple2 on the cross-arms.
Supply the needle bearings with lubrication until it comes out from under the working edges of the crosses glands.
The use of solid oil and mixtures containing it when lubricating needle bearings can cause them to quickly fail.
It is not necessary to insert excess lubricant into the splines, as it will be thrown out of the spline joint, which will