UAZ PATRIOT, Руководство по эксплуатации

Страница: 27 / 184

27
- do not carry out maintenance operation and repair of a motor
vehicle with engine on, except for specific works that require engine
start according to the procedure, with that take special care;
- avoid bringing hands, parts of clothing and tools dangerously
close to operating drive belts, pulleys, etc.;
- the fuel supply system is under pressure with the engine
running after the fuel pump, therefore it is prohibited to carry out
maintenance (e.g. tightening joints) repair of subsystems with engine
on or immediately after its shutdown;
- take due care when opening the radiator cap of the engine
cooling system to avoid scalding;
- before arc welding operations, execution tanks shall be removed
and battery "-" terminal shall be disconnected;
- observe fire safety rules.
32. Waste oils and specialty liquids shall be collected and sent
for recycling or disposal.
33. Several safety requirements are detailed in the respective
chapters of the Manual.
WARNINGS
1. During the initial operating period all recommendations
specified in chapter "New motor vehicle running-in" shall be strictly
observed.
2. Switching engine malfunction lamp on does not mean that
the engine must be shutdown immediately. However, in case of a
malfunction caused by ignition failures (engine wobble and jerking
when driving a motor vehicle), a motor vehicle shall be immediately
(max. in 0.5 min.) stopped, and the engine shall be shut off in order
to prevent exhaust gas catalyst breakdown.
3. Do not start motor vehicle driving with a cold engine. Avoid
high crankshaft speed after starting a cold engine.
In order to prevent any difficulties when starting engine, follow
the instructions in chapter "Engine start".
4. In case of abnormal noises and knocks in a running engine,
find out the cause of their occurrence, a motor vehicle must not be
operated until the malfunction is corrected.
4.1. After starting a cold engine the hydraulic valve may knock,
that should disappear in the course of engine warm-up to the
coolant temperature of 80-90°C, but not more than in 30 minutes
after reaching the specified temperature. If knock persists, it is