TYROLIT Hydrostress TBE350 Series, Руководство по эксплуатации

Страница: 17 / 27

17
TROUBLESHOOTING
Problem Possible Cause Solution
Irregular run of the
saw blade Poor tension in the blade
material Return the saw blade to the
manufacture
Saw blade wobbles
when running Saw blade is damaged or
bent - Have the saw blade
aligned/flattened
-
Clean the receiving flange
-
Solder the diamond segments of
the old blade onto another swa
blade or use a new blade
Flange of the saw blade is
damaged Replace the saw blade flange
Shaft of the motor is bent Replace the electric motor
Diamond segment
becomes loose Overheating of the saw
blade, cooling water not
sufficient
Have the diamond segment soldered on
the blade again, ensure optimum flow of
cooling water
Excessive wear Wrongtype of saw blade Use harder saw bldes
Shaft of motor causes
wobbling Have bearings of the motor or the motor
replaced
Overheating Ensure optimum flow of cooling water
Cracks in or near the
diamond segment Saw blade too hard Use a softer blade
Fixed flange is worn out Have the fixed flange replace
Motor shaft bearing Replace the bearing of the motor shaft