TYROLIT Hydrostress TBE350 Series, Руководство по эксплуатации

Страница: 16 / 27

16
TROUBLESHOOTING
Problem Possible cause Solution
Machine does not run
when switched on Power cord not properly
fixed / plugged in Check that the machine is properly
connected to the power supply.
Power cord defective Have the power cord checked, replace
if necessary.
Main power switch
defective Have the main power switch checked
and replace if necessary by a qualified
electrician.
Loose eleectrical
connection inside the
electric system Have the whole electric system of the
machine checked by a qualified
electrician.
Motor defective Have the motor checked and replace if
necessary by a qualified techician.
Motor stops
(power cut out) To much pressure exerted
while cutting Exert less pressure when cutting
Incorrect specification for
saw blade Use a saw blade which corresponds to
the material being cut
Saw has a defective electric
system Have the electric system of the saw
checked by a qualified technician
Poor machine
performance little
power Power cord/extension cable
too long or cable still wound
up inside cable drum Use a power cord/ectension cable of
the rated length, use a cable drum with
cable fully extended
Power network is
insufficient Observe the electrical ratings of the
machine and connect it only to a power
network which complies with these
ratings
Drive motor no longer runs
at rated speed (r.p.m.) Have the motor checked by a qualified
electrician and have it replaced if
necessary