TYROLIT Hydrostress TBE350 Series, Руководство по эксплуатации

Страница: 15 / 27

15
SAW MAINTENANCE
Maintenance interval Wath to do for maintenance and care
After ecery use ot the
machine
-
Remove dirty water from container.
-
Remove dirt and mud from the bottom of the container
-
Rinse teh immersion pump with fresh water to prevent water
pump dogging from residual dirt.
After wet clearing and
before using the machine
again Connect the machine to an electric power outlet equipped with
a“GFI” safety power breaker. If the safety power breaker cuts off
the electrical power supply, do not try to operate the machine but
have it checked by an authorized dealer first.
Before not using the
machine for a prolonged
period of time Clean and lubricate all movable part.
Before not using the
machine for a prolonged
period of time
-
Check that the stand is safely fixed.
-
Check that all screw joints and nuts are fixed.
-
Check that the roller table is in its guides and that it easliy
moves to and fro.
-
With the saw blade removed, switch on the motor for an
instant and switch it off again. If the motor does not run, have
the machine inspected by a qualified electrician.
-
Check that the immersion pump works properly. Turn on the
cooling water tap and switch the machine on. If the pump
does not give any water or only a little, switch the machine off
at once. Clean the pump, or replace of necessary.
Ambient temperture below
0°C (operation in winter) To prevent the water in the pump and cooling system from
freezing, remove the water after using the machine or when there
will be a long break. Make sure that the cooling system is entirely
drained so that there is no water left inside the pump, water hose
and bearing housing
For your safety, before performing any maintenance on the saw turn off
the power switch and unplug the power card