TYROLIT Hydrostress TBE350 Series, Руководство по эксплуатации

Страница: 10 / 27

10
THE RIP GUIDE
Steps to use the 45º / 90º rip guide
1. Set the rip guide by positioning it on the desired dimension and tighten the
threaded knob. Make sure that the rip guide is firmly tightened to avoid
slippage. The rip guide can be used for 90º rip cuts and 45º angle cuts from
both the left and right side. (Note the straight and 45º angled slits on the
bottom of the rip guide
2. After the rip guide is positioned for the desired cut, place material flat against
the rip guide and the measurement rail. After the rip guide is positioned for
the desired cut, place material flat against the rip guide and the measurement
rail. For 45º rip cuts, place the corner of material in the open slot of the
measurement rail.
3. Simply line up the material being cut with the appropriate pre-marked lines on
the cutting table.
4. Now you are ready to make your cut
CUTTING DEPTH
The recommended cutting depth is ¼" below the cutting table surface. The
cutting clearance has been fixed from original designed.
Only use the Ø14" (350 mm) blade for this saw. Setting smaller size of
diamond blade may grab the material being cut, causing damage and
possibly injury.
max. Blade Diameter max. Cutting Depth
400 mm 120 mm