Tyco Electronics FOSC-600 C, Руководство по установке

Страница: 8 / 16

8
In line configuration
3.5.9 Route and secure the spiral tube as shown. Insert the FOPT 50
mm inside the spiral tube and secure it to the basket.
Ribbon
A Loop storage in the basket
Preparation, termination and routing is done according to the
appropriate previous section (loose tube, central core, butt or in-
line).
3.5.11 Uncut loops can be stored in the basket. Secure them by
means of tie-wraps.
Note : do not tighten.
3.5.13 Put a piece of teflon tape at 1.2 meter on the straightened
ribbon bundle.
Note : the 1.2 meter is measured from the basket entrance (side
were tray holder is).
B Loop storage on trays
3.5.12 Take appropriate ribbons (bundles) out of the basket,
make sure all ribbons are positioned with the same color up and in
numerical order. Take all ribbons as shown and straighten them
over 1.2 meter (twists are pushed away from basket).
Note : the 1.2 meter is measured from the basket entrance (side
were tray holder is).
3.5.6 Mark the FOPT at 15 mm on the tray and remove the tube
excess. Secure the FOPT with 2 tie-wraps and trim the tails.