Tyco Electronics FOSC-600 C, Руководство по установке

Страница: 5 / 16

5
s Use the 2 outer leg
for dual SM attachment
bend down middle legs
3.3.1 Cut the strength member(s) at 32 mm.
Note : if shield is present, attach the bond wire to the sheath.
Use fork middle leg
for central SM attachment
bend down 2 outer legs
Loose tube
3.3.3 For central strength members , use the fork middle leg.
Slide the strength member into the strength member termination and
tighten the screw. Bend the fork outer legs out of the way.
Note : For large central strength members, use the larger square bolt
(only in 3 port kit).
3.3.2 Install the strength member termination onto the strength
member attachment forks depending the cable type.
3.3.4 For dual strength members , bend the fork middle leg
out of the way and use the two outer legs.
3.3.5 Install the strength member bracket into the cable
attachment assembly by pushing the metal tab into the slot.
3.3.6 Adjust the sheath retention clips until they grip the cable
sheath. Wrap a hose clamp around the sheath retention clips and
cable, secure the hose clamp.
Note : make sure that the hose clamp bolts are to the side of the
cable and will not be trapped between the cables and closure or
interfere with upper cable attachments.
3.3.7 Install top cable attachment assembly and secure with
the removed two pins. Repeat steps 3.3.2-3.3.7 if cables are
installed in the top ports.
Central core - Ribbon