Tyco Electronics FOSC-600 C, Руководство по установке

Страница: 10 / 16

10
3.5.18 All ribbon fibers have to be free of torsions when spliced. Take
the different ribbon fibers of one cable between two fingers (same
color up). Slide the fingers over the ribbon fibers, moving towards the
end of the cable. Refer to the splice manufacterer’s instructions for
directions of fiber splicing.
3.5.19 Cut the ribbon fibers at a length of110cm, measured from the
tray’s entrance (easier for storage in tray, see drawing at point 6.4.6).
Note : when intertray jumping is required, do not cut the ribbons
shorter before they are on the appropriate tray.
3.5.21 Route the ribbon fibers on the tray in an orderly fashion,
as shown on the drawing.
Note : Store the ribbons as much as possible in bundles. Avoid
crossings.
3.6 Fiber splicing and capacity
FOSC 600 C
Can contain up to 5 single fusion trays with a slack basket or 3
ribbon trays with no slack basket.
FOSC 600 D
Can contain up to 9 single fusion trays with a slack basket or 6
ribbon trays with no slack basket.
3.5.20 On the tray there’s the possibility to store the splices in
two different compartments (top and bottom). The first completed
splices have to be stored in the bottom compartment, in the splice
holders farthest from the hinge. When all bottom slots are full, the
top slots can be filled.
3.5.17 In case a loop needs to be spliced, cut the ribbon in the middle
of the loop. Clean the ribbons.
C Splicing of ribbons