Tyco Electronics FOSC-600 C, Руководство по установке

Страница: 3 / 16

3
3.1.5 Open the latches.
3.1.6 Loosen the bolts and lift the top part, revealing the closure
bottom part. Leave the bolts in the top part of the closure.
3.1.4 Deburr the edges. 3.1.7 Make sure the groove and rubber seal are clean. Insert
the rubber seal correctly.The small edge of the rubber seal has to
match the small slot in the seal cavity (see arrow).
3.1.8 Insert the rubber seal in the groove starting at the open
port.
Note : do not stretch the seal.
3.1.9 If the seal is too long at the end; cut the excess.
3.1.10 For an in-line application, it is necessary to open two
ports.
For a butt application, it might be necessary to open a second
port, depending the cable configuration.
Note: when opening a second port, close the closure with the seal
installed and repeat the steps 3.1.1 till 3.1.4.